MAAT MGF1-2BG Automatic Pump Control unit
KSh2,999.00
Key Features & Design
-
Automatic Start/Stop Logic: Automatically energizes the pump when a tap, valve, or appliance is opened (sensing a drop in pressure), and powers it off when flow ceases.
-
Dry-Run (No-Water) Protection: Built-in flow sensor continuously monitors water intake. If the supply well or tank runs dry, the controller trips power to the pump automatically to prevent seal and impeller failure.
-
Integrated Pressure Gauge: Front-mounted analog gauge provides real-time visual inspection of line system pressure.
-
Manual Reset Button (
RESET): Located on the front panel to easily restart the system after a dry-run fault is cleared or power is restored. -
Eliminates Traditional Expansion Tanks: Functions as an all-in-one replacement for traditional mechanical pressure switches, brass 5-way connectors, and bulky pressure bladder tanks in standard booster setups.
MAAT MGF1-2BG is an electronic automatic pump pressure controller designed to automate the starting and stopping of single-phase electric water pumps (surface, submersible, or centrifugal) based on line pressure drops and flow detection. It also acts as an essential safeguard by shutting off the pump during dry-run conditions to prevent motor burnout.
Technical Specifications
-
Input Voltage: 220–240 V AC ~ 50/60 Hz
-
Maximum Current Rating: 10 A (Direct switching up to ~1.1 kW / 1.5 HP pumps; requires a contactor/relay for larger motors)
-
Maximum Allowable Pressure: 10 Bar (1.0 MPa)
-
Pre-Set Starting Pressure (Cut-In): 1.5 Bar (Factory standard)
-
Maximum Operating Temperature: 60°C
-
Protection Rating: IP65 (Dust-tight and water-jet resistant housing)
-
Connection Port Diameter: 1″ Male BSP Thread (G1″ Inlet/Outlet)
-
Integrated Accessories: Built-in mechanical pressure gauge (0–10 Bar range)

Reviews
There are no reviews yet.